1. Produktüberschreitungview
This manual provides instructions for the installation, maintenance, and troubleshooting of the Whirlpool Refrigerator Water Filter, model SBS002 / C00311642. This genuine replacement filter is designed to reduce impurities and chlorine, providing cleaner, better-tasting water and ice from your refrigerator dispenser.
Image 1.1: Whirlpool SBS002 / C00311642 Refrigerator Water Filter. This image shows the cylindrical filter cartridge with its connection points.
2. Sicherheitshinweise
Always observe basic safety precautions when installing or replacing the water filter. Failure to do so may result in property damage or personal injury.
- Ensure the refrigerator's water supply is turned off before beginning the installation process.
- Wenn Sie sich bei einem Arbeitsschritt unsicher sind, konsultieren Sie einen qualifizierten Techniker.
- Nicht mit mikrobiologisch unsicherem Wasser oder Wasser unbekannter Qualität verwenden, ohne vor oder nach dem System eine ausreichende Desinfektion durchzuführen.
- Bewahren Sie den Filter außerhalb der Reichweite von Kindern auf.
3. Installationsanweisungen
Follow these steps to replace your refrigerator's water filter:
- Wasserzufuhr abstellen: Locate the water shut-off valve for your refrigerator and turn it off. This is typically located behind the refrigerator or under the sink.
- Alten Filter suchen: The filter is usually located in the upper right corner of the refrigerator compartment, in the base grille, or inside a compartment on the door. Refer to your refrigerator's specific user manual for exact location.
- Alten Filter entfernen:
- If the filter is a push-in type, push the release button or turn the filter counter-clockwise a quarter turn to release it.
- If the filter is a twist-in type, twist it counter-clockwise until it unlocks and pull it out.
Note: Some water may drip when removing the old filter. Have a towel ready.
- Neuen Filter vorbereiten: Remove the new filter from its packaging. Remove any protective caps or covers.
- Neuen Filter installieren:
- For push-in filters: Align the new filter with the housing and push it firmly until it clicks into place.
- For twist-in filters: Insert the new filter into the housing and twist it clockwise until it locks securely.
- Wasserzufuhr einschalten: Turn the refrigerator's water shut-off valve back on.
- Spülen Sie das System: Dispense approximately 3-4 gallons (12-15 liters) of water through the dispenser to flush out air and carbon fines from the new filter. This may take about 5 minutes.
- Auf Lecks prüfen: Inspect the filter area for any signs of water leaks.
- Filteranzeige zurücksetzen: Most refrigerators have a filter indicator light. Refer to your refrigerator's manual for specific instructions on how to reset it. This usually involves pressing and holding a "Filter Reset" button for a few seconds.
4. Wartung
For optimal performance and water quality, it is recommended to replace your Whirlpool water filter every 6 months or sooner if water flow noticeably decreases or the filter indicator light illuminates.
5. Fehlerbehebung
| Problem | Mögliche Ursache | Lösung |
|---|---|---|
| Wasser tritt aus dem Filterbereich aus | Filter not seated correctly; O-rings damaged or missing. | Ensure filter is fully inserted and locked. Remove and re-install the filter. Check O-rings for damage. |
| Low water flow from dispenser | Air in the system; clogged filter; kinked water line. | Flush the system for several minutes. Replace filter if old. Check water line for kinks. |
| Die Filterkontrollleuchte bleibt nach dem Austausch an. | Indicator not reset properly. | Refer to your refrigerator's manual for specific filter reset instructions. Typically involves holding a button for 3-5 seconds. |
| Cloudy or discolored water initially | Air bubbles or carbon fines from new filter. | This is normal. Continue flushing the system until water runs clear. |
6. Spezifikationen
- Modell: C00311642 (SBS002)
- Marke: Whirlpool
- Produktvorteile: Removes impurities, Reduces chlorine
- Zertifizierung durch externe Prüfer: CE
- Artikelgewicht: 1 Gramm
- Hersteller: Whirlpool
- Ursprungsland: Taiwan
7. Kompatibilität
This Whirlpool water filter (SBS002 / C00311642) is compatible with various refrigerator models from brands including Whirlpool, Admiral, Amana, Hotpoint, Ikea, KitchenAid, and Maytag. For a comprehensive list of compatible models, please refer to the product details on the retailer's website or your refrigerator's user manual.
Zu den kompatiblen Modellen gehören unter anderem:
- Admiral: GC2027HNKBS, GC2027HXKSI, SAL2027GBB, SAL2027GBS
- Maitag: MAL2028GBB, MAL2028GBS, MC2027HEKB, MC2028HXKB, MSS20FBB4, MSS20FIS4
- Whirlpool: 20FB-L4/A, 20RB-D3J, 20RI-D4ESPRESSO, 20RU-D3L, S20BRSS31-A/G, WSC5553AX
- KitchenAid: KRSCC9005/A, KRSC9010/I, KRSF9005/BL
- Amana: GC2027GNKBS
- (This is a partial list. Always verify compatibility with your specific appliance model.)
8. Garantie und Support
For warranty information, technical support, or to purchase replacement filters, please contact Whirlpool customer service or visit their official webBewahren Sie Ihren Kaufbeleg als Kaufnachweis auf.
For return policies, please refer to the retailer's specific return guidelines where the product was purchased.