Cell2 Handbücher & Benutzerhandbücher

Cell2 B14 Magnetic Mount LED Beacons WIRING & OPERATION RED: To +VDC BLACK: To Chassis Ground (-) WHITE: For Simultaneous or Alternating Flash Group1 Units: (Wiring- \WJ[H]~'jj'~ connected to RED)…

Cell2 EGION-FIT Legion FIT Cruise (H002) Speaker WIRING & FUNCTIONS (AM/AN) Different applications require different functions. It is highly recommended to determine and configure the required functions prior to Installation;…

Cell2 CR06-DC Led Flush Mount Kit WIRING OPERATION For Flash Pattern Selection While in Warning Mode, momentarily apply +VDC to YELLOW wire: once to next pattern quickly three times to…

Cell2 SL157 Exterior Scene Light WIRING INSTALLATION Place the foam pad onto the desired mounting surface and mark the location for the two mounting screws and the wire routing hole…

R0 Oberflächenmontierte Szene Lamp Benutzerhandbuch R0 Surface Mount Scene Lamp WIRING: To +VDC(fuse rating @ 0.5A)...................................................... RED To Vehicle Chassis Ground: ..........................................................BLACK (For steady-bum models, external flasher may…

SW830-2 Multi-Purpose Switch Control Panel Instruction Manual INSTALLATION It is essential to install the unit properly to ensure safe and reliable operation. Please read through all instructions thoroughly and carefully…

RAYZR Lighthead 3LED TIR User Manual RAYZR Lighthead 3LED TIR WIRING FOR WARNING STICKS RED ........................[+] Warning Mode to +VDC with rated fuse (for correct rating, refer to the Fuse…

Commander SE4 Traffic Director 8 Lighthead User Manual INSTALLATION Remove endcap (side without cable) and insert mounting carriage bolts. For Surface Mount, drill 1/4" (6.3mm) holes to the mounting surface.…

LP6 LED Pad User Manual Surface Mount NOTE: When using adhesive mount, ensure that the mounting surface is clean, dry and well unified before mounting. Connect BROWN wires of all…

SceneMax Warning Modules User Manual SceneMax Warning Modules WIRING MOUNTING DIMENSIONS OPERATION For Flash Pattern Selection: Each Warning Memory may select and save one flash pattern. While activating a warning…