1. Wichtige Sicherheitshinweise
Read all instructions before installing or using this heater. Failure to follow these instructions may result in fire, electric shock, or personal injury.
- Elektrischer Anschluss: This heater operates on 240 Volts. All wiring must be performed by a qualified electrician in accordance with national and local electrical codes.
- Platzierung: Do not install the heater directly below a wall receptacle. Maintain minimum clearances from combustible materials as specified in the installation section.
- Überhitzungsschutz: This heater is equipped with an automatic overheat shutoff feature for safety. If the heater overheats, it will automatically turn off. To reset, disconnect power for a few minutes and then reconnect. If the issue persists, contact a qualified service person.
- Wassereinwirkung: Do not use this heater in bathrooms, laundry areas, or similar locations where it may come into contact with water. Never immerse the heater in water.
- Kinder und Haustiere: Halten Sie Kinder und Haustiere vom Heizgerät fern. Die Oberfläche des Heizgeräts kann sich während des Betriebs erhitzen.
- Luftstrom: Do not block air openings. Ensure proper airflow around the heater to prevent overheating.
2. Produktüberschreitungview
The Dimplex LC3010W31 is a 30-inch linear convector electric baseboard heater designed for efficient and quiet heating. Its compact and sleek design allows for versatile placement in various indoor spaces.

Abbildung 2.1: Vorderseite view of the Dimplex LC3010W31 Linear Convector Electric Baseboard Heater.
Zu den Hauptmerkmalen gehören:
- Schnelles Aufheizen: Designed for rapid heat dispersal into the room.
- Leiser Betrieb: Features a superior shark-fin blade design on a steel tubular element for efficient and quiet heat transfer.
- Langlebige Konstruktion: Made with polyester/epoxy powder coating to resist fading and abrasion, and a nickel chromium element for extended life and rust resistance.
- Kompaktes Design: Up to 42% smaller than conventional baseboard heaters, offering discreet styling and flexible installation.
3. Installation
Installation of this 240V electric baseboard heater requires electrical wiring. It is strongly recommended that installation be performed by a qualified electrician to ensure compliance with all local and national electrical codes.
3.1 Montageort
- The heater is designed for floor mounting.
- Stellen Sie sicher, dass die Montagefläche eben und stabil ist.
- Maintain adequate clearance from walls, furniture, drapes, and other combustible materials. Refer to local codes for specific requirements.
- Do not obstruct the air intake or discharge vents.

Figure 3.1: Dimensions of the Dimplex LC3010W31 heater. The heater is approximately 30 inches long, 2.38 inches deep, and 6.62 inches high.
3.2 Elektrischer Anschluss
- Ensure the main power supply to the circuit is turned off at the breaker panel before beginning any wiring.
- Connect the heater to a dedicated 240V circuit as per the wiring diagram provided with the product packaging.
- All connections must be secure and properly insulated.

Abbildung 3.2: Bspample installation of the Dimplex LC3010W31 heater in a bathroom setting.

Abbildung 3.3: Bspample installation of the Dimplex LC3010W31 heater in a kitchen area.
4. Bedienung
This baseboard heater does not include an integrated thermostat. An external wall-mounted thermostat (sold separately) is required for temperature control. Once properly installed and wired to an external thermostat, operation is straightforward.
- Ein-/Ausschalten: The heater will turn on and off based on the settings of the external thermostat. Ensure the circuit breaker supplying power to the heater is in the 'ON' position.
- Temperatureinstellung: Adjust the desired room temperature using your external thermostat.
- Erste Verwendung: When first operated, the heater may emit a slight odor or smoke. This is normal and temporary, caused by the burning off of manufacturing residues. Ensure the area is well-ventilated during initial use.
5. Wartung
Regular maintenance ensures optimal performance and longevity of your heater. Always disconnect power to the heater at the main circuit breaker before performing any maintenance.
- Reinigung: Reinigen Sie die Außenseite des Heizgeräts regelmäßig mit einem weichen, fusselfreien Tuch.amp Tuch. Keine Scheuer- oder Lösungsmittel verwenden.
- Dust and Lint: Use a vacuum cleaner with a brush attachment to remove dust and lint from the grilles and interior of the heater. Accumulated dust can reduce efficiency and pose a fire hazard.
- Keine vom Benutzer zu wartenden Teile: This heater contains no user-serviceable parts. Do not attempt to repair or modify the heater yourself. Contact a qualified service technician for any repairs.
6. Fehlerbehebung
If you experience issues with your Dimplex LC3010W31 heater, refer to the following common troubleshooting steps:
- Heizung schaltet sich nicht ein:
- Check the circuit breaker for the heater's circuit. Ensure it is in the 'ON' position.
- Verify that the external thermostat is set to a temperature above the current room temperature.
- Ensure the heater is properly wired and all electrical connections are secure.
- Heater Not Heating Effectively:
- Confirm the external thermostat is functioning correctly and set appropriately.
- Check for obstructions around the heater that might be blocking airflow.
- Ensure the room is adequately insulated and free from excessive drafts.
- Heizung schaltet sich unerwartet ab:
- The overheat protection may have activated. Disconnect power at the circuit breaker for 5-10 minutes, then restore power.
- Check for blocked air vents or excessive dust accumulation.
- If the issue persists, contact a qualified electrician or service technician.
7. Spezifikationen
| Spezifikation | Detail |
|---|---|
| Modellnummer | LC3010W31 |
| Marke | DIMPLEX |
| Bandtage | 240 Volts (also compatible with 208 Volts) |
| Wastage | 1000 Watt |
| AmpAlter | 4.8 Amps |
| Produktabmessungen (T x B x H) | 30" x 2.38" x 6.62" (76.2 cm x 6 cm x 16.9 cm) |
| Artikelgewicht | 4 Pfund |
| Farbe | Weiß |
| Material | Polyester/Epoxy Powder Coated Steel |
| Montagetyp | Bodenhalterung |
| Besondere Merkmale | Fast Heating, Overheat Protection |
| Verwendung im Innen- und Außenbereich | Innenbereich |
| Heizungsabdeckung | Up to 300 square feet (approximate, depends on insulation) |
8. Kundendienst
For further assistance, technical support, or warranty information, please contact Dimplex customer service. Refer to the product packaging or the official Dimplex webDie Website enthält die aktuellen Kontaktdaten.





