SwellPro FD3 Fischerdrohne Benutzerhandbuch

1. Einleitung

This manual provides essential instructions for the safe operation, setup, and maintenance of your SwellPro FD3 Fisherman Waterproof Fishing Drone. The FD3 is designed for marine environments, featuring IP67 waterproofing, a 4K camera, and a dual bait release mechanism for fishing applications. Please read this manual thoroughly before operating the drone to ensure proper use and to prevent damage or injury.

Sicherheitshinweise

• Die Drohne darf nur in offenen Bereichen, fernab von Menschen, Tieren und Hindernissen, betrieben werden.
• Halten Sie während des Betriebs einen sicheren Abstand zur Drohne ein.
• Do not operate the drone in strong winds, heavy rain, or lightning.
• Stellen Sie sicher, dass alle Batterien vor jedem Flug vollständig aufgeladen sind.
• Regularly inspect the drone for any damage before and after use.
• Adhere to all local regulations and laws regarding drone operation.

2. Packungsinhalt

Verify that all items listed below are present in your package. If any items are missing or damaged, please contact SwellPro support.

Abbildung 2.1: The SwellPro FD3 Fisherman drone shown with its primary accessories, including the remote control, flight battery, charger, and bait release mechanism.

• SwellPro FD3 Fisherman Drone (x1)
• Fernbedienung (x1)
• Intelligenter Flugakku (x1)
• Akkuladegerät (x1)
• Propellers (sets)
• Dual Bait Release Mechanism (x1)
• Benutzerhandbuch (dieses Dokument)
• Other accessories (e.g., cables, tools)

3. Einrichtung

3.1 Drohnenmontage

1. Propeller anbringen: Carefully attach the propellers to the motor shafts. Ensure correct propeller type (CW/CCW) matches the corresponding motor. Tighten securely.
2. Flugbatterie einbauen: Insert the intelligent flight battery into the drone's battery compartment until it clicks into place.
3. Attach Bait Release Mechanism: Secure the dual bait release mechanism to the drone's underside according to the provided diagrams. Ensure it is firmly attached and cables are connected.
4. Kamera installieren: Mount the 4K camera onto its designated gimbal or mounting point, ensuring all connections are secure.

Abbildung 3.1: Von oben nach unten view of the SwellPro FD3 drone, illustrating the propeller and motor configuration. Ensure propellers are correctly installed for safe flight.

3.2 Laden der Batterie

Charge both the intelligent flight battery and the remote controller battery before first use and after each flight.

• Schließen Sie das Batterieladegerät an eine Steckdose an.
• Connect the flight battery to the charger. The indicator light will show charging status.
• Connect the remote controller to its charger (usually via USB).
• Charge until all indicator lights show a full charge.

3.3 Einrichtung der Fernbedienung

Abbildung 3.2: The SwellPro FD3 drone positioned next to its remote control, which features a built-in display for real-time flight data and camera feed.

Power on the remote controller. If it does not automatically connect to the drone, follow the binding procedure outlined in the quick start guide or the full manual (if available separately) to establish a connection.

3.4 App-Installation (optional)

For advanced features and real-time telemetry, download the official SwellPro app from your device's app store. Follow the in-app instructions to connect your drone and remote controller.

4. Betrieb der Drohne

4.1 Checkliste vor dem Flug

• Stellen Sie sicher, dass alle Akkus (Drohne und Fernbedienung) vollständig geladen sind.
• Prüfen Sie die Propeller auf Beschädigungen und stellen Sie sicher, dass sie fest angebracht sind.
• Verify the bait release mechanism and camera are properly installed.
• Check the weather conditions (wind speed, rain).
• Ensure sufficient GPS signal (if operating in GPS mode).
• Clear the flight area of any obstacles, people, or animals.

Abbildung 4.1: The SwellPro FD3 drone in flight over water, demonstrating its waterproof capabilities. Always perform a pre-flight check before launching.

4.2 Grundlegende Flugsteuerung

Refer to the remote controller diagram (usually found in the quick start guide) for specific stick and button functions. Common controls include:

• Linke Stange: Throttle (up/down), Yaw (rotate left/right)
• Rechter Stick: Pitch (forward/backward), Roll (left/right)
• Zurück-zur-Startseite-Schaltfläche (RTH): Leitet die automatische Rückkehr zum Startpunkt ein.
• Köderauslöseknopf: Activates the bait release mechanism.
• Kamerasteuerung: Buttons for photo capture and video recording.

4.3 Bait Release Operation

1. Securely attach your fishing line with bait to the dual bait release mechanism. Ensure the weight does not exceed the drone's maximum payload capacity (4.4 lbs).
2. Fly the drone to your desired casting location.
3. Once in position, press the dedicated bait release button on the remote controller. The mechanism will open, dropping the bait.
4. Confirm the bait has been released via the camera feed or visual observation.

4.4 Betrieb der 4K-Kamera

• Ensure a compatible microSD card is inserted into the camera.
• Use the dedicated buttons on the remote controller to start/stop video recording or take photos.
• The live video feed will be displayed on the remote controller's screen or connected mobile device.

4.5 Auto Drop & Return

The FD3 features intelligent flight functions:

• Auto Drop: This refers to the automated bait release function, triggered by the remote controller.
• Rückkehr nach Hause (RTH): When activated, the drone will automatically fly back to its recorded takeoff point and land. This feature is also triggered automatically if the battery level is critically low or if the control signal is lost.

5. Wartung

5.1 Reinigung

• After use, especially in saltwater environments, rinse the drone thoroughly with fresh water.
• Wipe the drone dry with a soft cloth. Ensure all ports and connectors are free of moisture before charging or storing.
• Reinigen Sie das Kameraobjektiv mit einem Mikrofasertuch.

5.2 Speicherung

• Drohne und Batterien sollten an einem kühlen, trockenen Ort, fern von direkter Sonneneinstrahlung und extremen Temperaturen, aufbewahrt werden.
• For long-term storage, discharge batteries to approximately 50-60% capacity.
• Remove propellers if storing in a compact case.

5.3 Batteriepflege

• Batterien nicht überladen oder zu stark entladen.
• Sollte eine Batterie aufgebläht oder beschädigt erscheinen, stellen Sie die Verwendung sofort ein und entsorgen Sie sie sachgemäß.
• Avoid puncturing or exposing batteries to extreme heat.

6. Fehlerbehebung

7. Spezifikationen

8. Garantie und Support

For warranty information, please refer to the warranty card included with your product or visit the official SwellPro website. For technical support, troubleshooting assistance, or spare parts, please contact SwellPro customer service.

SwellPro Official WebWebsite: www.swellpro.com

Amazon Store: Visit the SwellPRO Store on Amazon