Einführung
This manual provides essential information for the safe and efficient operation, installation, and maintenance of your GAME 7011-E Sand Filtration System. This system is designed for above-ground pools up to 25,000 gallons, featuring a 16-inch filter tank, a 3/4 HP pump, and a digital timer for automated filtration cycles. Please read all instructions carefully before assembly and use.
Sicherheitshinweise
WARNUNG: Die Nichtbeachtung dieser Anweisungen kann zu schweren Verletzungen oder zum Tod führen.
- Vor jeglichen Wartungs- oder Instandhaltungsarbeiten muss die Stromzufuhr zur Pumpe unterbrochen werden.
- Ensure the electrical supply is protected by a Ground Fault Circuit Interrupter (GFCI).
- Die Pumpe darf nicht in Betrieb genommen werden, wenn das Netzkabel oder der Stecker beschädigt ist.
- Keep children away from the filtration system during operation.
- The system must be installed on a solid, level surface.
- Vergraben Sie das Netzkabel nicht.
- Consult a qualified electrician for electrical connections if unsure.
Packungsinhalt
Prüfen Sie vor Beginn der Montage, ob alle unten aufgeführten Komponenten vorhanden und unbeschädigt sind.
Image: A visual representation of all components included in the package, such as the six-way valve, sand filter tank, pump, hoses, and hardware.
- Six-Way Valve
- 16-inch Sand Filter Tank
- 16-inch Sand Filter Tank Base
- 16-inch Manifold Tube
- Manifold Lateral Assembly
- Flansch Klamp
- 0.75 HP Pump & Motor Assembly & Base
- Sandschild
- Fasteners, Hardware & Gaskets
- Manometer
- Sand Filter Tank Drain Plug
- 20", 40" & 120" Hoses
- Siebkorb
- Strainer Basket Lid
- Motor Drain Plug
- Schauglas
Montage und Installation
Follow these steps for proper assembly and installation of your sand filtration system.
Image: The complete GAME 7011-E Sand Filtration System, including the sand filter tank, pump, and multi-port valve.
- Positionierung des Systems: Place the filter system on a firm, level surface, preferably concrete, at least 2 feet from the pool. Ensure the location allows for proper drainage when backwashing.
- Assembling the Tank Base: Secure the sand filter tank onto its base.
- Installing Lateral Assembly: Insert the manifold lateral assembly into the bottom of the filter tank. Ensure laterals are spread evenly.
- Hinzufügen von Filtersand: Carefully pour approximately 120 pounds of #20 silica sand (0.45-0.55mm) into the filter tank. Ensure the manifold tube remains centered during this process. Fill the tank about two-thirds full.
- Attaching the Six-Way Valve: Place the six-way valve onto the top of the filter tank, aligning the ports. Secure it with the flange clamp, ensuring a tight seal. Use a #3 Phillips screwdriver for the clamp screws and ensure washers are used to prevent damage to the plastic flange. Align the clamp openings with the ridges on the valve.
- Anschließen der Pumpe: Attach the pump to the six-way valve using the provided hoses and fittings. Ensure all connections are tight to prevent leaks. The system uses 1.5-inch inlet and outlet connections.
- Connecting to Pool: Connect the pool's skimmer line to the pump's inlet and the pool's return line to the six-way valve's 'RETURN' port using the provided hoses.
- Installation des Manometers: Screw the pressure gauge into the designated port on the six-way valve.
- Filling the Pump with Water: Before starting, remove the strainer basket lid and fill the pump with water to prime it. Replace the lid securely.
- Elektrischer Anschluss: Plug the 7.9-meter power cord into a GFCI-protected outlet.
Image: The compact sand filtration system positioned beside an above-ground pool, demonstrating its suitable size for various setups.
Betrieb
The GAME 7011-E Sand Filtration System features a 6-way valve and a digital timer for controlling filtration cycles.
Bild: Ein überview highlighting the pressure gauge for monitoring system performance, the 6-way valve for controlling water flow, and the strainer basket for pre-filtering debris.
Funktionen des 6-Wege-Ventils
Um Schäden zu vermeiden, schalten Sie die Pumpe immer aus, bevor Sie die Ventilposition ändern.
- FILTER: Normal filtering mode. Water flows through the sand, trapping debris, and returns to the pool.
- RÜCKSPÜLUNG: Cleans the filter sand by reversing water flow, sending dirty water to waste. Use when pressure gauge reads 8-10 PSI above starting pressure.
- SPÜLEN: Used after backwashing to flush out any remaining dirty water from the valve and sand bed to waste before returning to FILTER mode.
- ABFALL/ABFLUSS: Bypasses the filter, sending water directly to waste. Useful for lowering pool water level or vacuuming heavy debris directly to waste.
- REZIRKULIEREN: Umgeht den Filter und leitet das Wasser direkt zurück in den Pool. Nützlich zum Mischen von Chemikalien ohne vorherige Filterung.
- GESCHLOSSEN: Unterbricht den gesamten Durchfluss zum Filter und zur Pumpe. Zur Wartung der Pumpe oder des Filters verwenden.
Digitaler Timer-Betrieb
Image: Close-up of the integrated digital timer, allowing for programmable filtration cycles.
The digital timer allows for automated control of filtration cycles. Refer to the timer's specific instructions for setting daily run times. Ensure the timer is set to provide adequate filtration for your pool size and usage, typically 8-12 hours per day.
Wartung
Regular maintenance ensures optimal performance and longevity of your filtration system.
- Rückspülen: Perform backwashing when the pressure gauge reads 8-10 PSI above its clean starting pressure, or when water flow to the pool decreases significantly.
- Spülen: Always rinse for 30-60 seconds after backwashing to settle the sand and prevent dirty water from returning to the pool.
- Strainer Basket Cleaning: Regularly inspect and clean the pump's strainer basket. Turn off the pump, close necessary valves, remove the lid, empty debris, and replace.
- Sandersatz: Filter sand typically needs to be replaced every 3-5 years, depending on usage and water chemistry.
- Überwinterung: In cold climates, drain all water from the pump and filter tank to prevent freezing damage. Store the pump and valve indoors if possible.
Fehlerbehebung
This section addresses common issues you might encounter with your sand filtration system.
| Problem | Mögliche Ursache | Lösung |
|---|---|---|
| Wasser tritt aus den Anschlüssen aus | Loose fittings, worn O-rings/gaskets, improper clamp Ausrichtung. | Tighten all connections. Inspect and replace O-rings/gaskets if damaged. Ensure flange clamp is correctly aligned and tightened. |
| Sand kehrt in den Pool zurück | Damaged laterals, incorrect sand type/size, insufficient rinse after backwash. | Check laterals for damage. Ensure correct #20 silica sand is used. Perform a thorough rinse cycle after backwashing. |
| Geringer Wasserdurchfluss/Druck | Clogged strainer basket, dirty filter sand, air in the system, closed valves. | Clean strainer basket. Backwash and rinse filter. Bleed air from the system. Ensure all necessary valves are open. |
| Pumpe saugt nicht an | Insufficient water in pump, air leak in suction line, clogged skimmer/main drain. | Fill pump with water. Check all suction line connections for air leaks. Clear any blockages in skimmer or main drain. |
| Excessive pump noise | Lack of water, air in system, cavitation, motor bearing issue. | Ensure pump is fully primed. Check for air leaks. Verify adequate water supply to pump. If noise persists, contact support. |
Technische Daten
| Besonderheit | Detail |
|---|---|
| Marke | SPIEL |
| Modellnummer | 7011-D |
| Pump Horsepower | 0.75 PS |
| Pumpendurchflussrate | 3,698 GPH |
| Größe des Filtertanks | 16 Zoll |
| Sandkapazität | 120 Pfund |
| Maximale Poolkapazität | Bis zu 25,000 Gallonen |
| Anschlussgröße Einlass/Auslass | 1.5 Zoll |
| Länge des Netzkabels | 7.9 Meter |
| Abmessungen (L x B x H) | 15.7 x 26.7 x 30.1 Zoll |
| Artikelgewicht | 42.7 Pfund |
| Sicherheitsmerkmal | Eingebauter GFCI |
Garantie und Support
The GAME 7011-E Sand Filtration System comes with a 2 Jahr Herstellergarantie. For warranty claims, technical assistance, or replacement parts, please contact GAME customer support. Refer to the product packaging or the official GAME webWebsite für aktuelle Kontaktinformationen.
Image: The sand filtration system integrated with a GAME SCG (Saltwater Chlorinator Generator) system, illustrating compatibility.
