Carnegie Robotics 55001384 Autonomie-Controller-Modul
Technische Daten
- Hersteller: Carnegie Robotics
- Modellnummer: 55001384
- Integrationsanleitung: KDB 996369 D03 OEMManual v01
Beschreibung
Qualcomm® Robotics RB5 Core Kit consisting of Thundercomm TurboX C865 System on Module with customization around 12GB Ram and external antennas enabled for system integration. See Qualcomm or Thundercomm hardware manuals for specifications to each product.
Integrationsanweisungen für Hostprodukthersteller gemäß KDB 996369 D03 OEM Manual v01 (ISED anerkannt)
Liste der geltenden FCC-Regeln
- CFR 47 FCC PART 15 SUBPART C&E has been investigated. It is applicable to the modular. Specifically, an assessment of the worst case operating conditions has to be performed by the module integrator and tested on the host product for compliance to FCC part 15.247 and part 15.407.
Spezifische betriebliche Einsatzbedingungen
- Dieses Modul ist ein eigenständiges Modul. Wenn das Endprodukt mehrere gleichzeitige Sendevorgänge oder unterschiedliche Betriebsbedingungen für einen eigenständigen modularen Sender in einem Host erfordert, muss der Host-Hersteller die Installationsmethode im Endsystem mit dem Modulhersteller abstimmen.
- Eingeschränkte Modulverfahren. – Nicht anwendbar
- Trace-Antennendesigns. – Nicht zutreffend
Überlegungen zur HF-Exposition
- To maintain compliance with FCC’s and ISED’s RF Exposure guidelines, this equipment should be installed and operated at a minimum distance of 20cm from your body.
Antennen
- This radio transmitter FCC ID: 2AMDR-55001384 / IC: 24410-55001384 has been approved by the Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
| Intern
Identifikation |
Antennenbeschreibung | Antennentyp | Maximaler Antennengewinn |
| Antenne 0** | Wi-Fi-Antenne | Externe Antenne 2X MIMO WIFI | 2.4G Wi-Fi: 1.2 dBi,
5G Wi-Fi: 2.0dBi |
| Antenne 1 | Wi-Fi-Antenne | Externe Antenne 2X MIMO WIFI | 2.4G Wi-Fi: 1.2 dBi,
5G Wi-Fi: 2.0dBi |
- Bluetooth has been disabled on device and has not been tested
Antennas Tested
- Abracon Part Number AECW0401W2-0600F_DS
- Taoglas MA210.K.CG.001
Kennzeichnungs- und Konformitätsinformationen.
- The final end product must be labeled in a visible area with the following: Contains FCC ID: 2AMDR-55001384, IC: 24410-55001384
Informationen zu Prüfungsmodi und zusätzlichen Prüfungsanforderungen
- The Host manufacturers are strongly recommended to confirm compliance with FCC and ISED requirements for the transmitter when the module is installed in the host. Additional testing, Part 15 Subpart B and ICES-003 disclaimer The host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for the system such as FCC Part 15 B and ICES-003.
FCC-Warnung
- Jegliche Änderungen oder Modifikationen, die nicht ausdrücklich von der für die Konformität verantwortlichen Partei genehmigt wurden, können zum Erlöschen der Berechtigung des Benutzers zum Betrieb des Geräts führen.
FCC and ISED Statements
This device complies with Part 15 of the FCC Rules and with ICES-003 of the ISED rules. Operation is subject to the following two conditions:
- Dieses Gerät darf keine schädlichen Störungen verursachen und
- Dieses Gerät muss alle empfangenen Störungen tolerieren, einschließlich Störungen, die einen unerwünschten Betrieb verursachen können.
WICHTIGER HINWEIS:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of the ISED Canada rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Empfangsantenne neu ausrichten oder verlegen.
- Vergrößern Sie den Abstand zwischen Gerät und Empfänger.
- Schließen Sie das Gerät an eine Steckdose an, die zu einem anderen Stromkreis gehört als der Empfänger.
- Wenden Sie sich an Ihren Händler oder einen erfahrenen Radio-/Fernsehtechniker.
Statements regarding human exposure
- With respect to radiofrequency radiation exposure Information, it is declared that this equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment.
- This equipment should be installed and operated at a minimum distance of 20 cm between the radiator and your body.
- Dieser Sender darf nicht am selben Standort wie eine andere Antenne oder ein anderer Sender aufgestellt oder zusammen mit diesen betrieben werden.
FAQs
What are the recommended distances for RF exposure compliance?
The equipment should be installed and operated at a minimum distance of 20cm from the body to comply with FCC's and ISED's RF Exposure guidelines.
Can I use antennas not listed in the manual?
Antenna types not included in the approved list are strictly prohibited for use with this device to maintain compliance.
Dokumente / Ressourcen
 |
Carnegie Robotics 55001384 Autonomie-Controller-Modul [pdf] Bedienungsanleitung 55001384, 2AMDR-55001384, 2AMDR55001384, 55001384 Autonomie-Controller-Modul, 55001384, Autonomie-Controller-Modul, Controller-Modul, Modul |